I did a fresh openhab2 (openhabian) install on Raspberry Pi. Added the following bindings:
Alarmdecoder
Yamaha Receiver
openHAB cloud connector
HABmin
Then I copied z-wave binding from OH2 Z-Wave refactoring and testing... and SECURITY.
I launched HABmin and added the z-wave controller and configured the port. I then turned discovery on and unplugged the z-wave controller to include GoControl Garage Door opener. After including the garage opener, I plugged the z-wave stick back in Pi but after the garage opener didn’t get discovered, I rebooted the Pi. Now the garage opener showed up in discovery and I added it.
“Using Security” was still not showing green. Here is the log:
2017-04-30 14:40:23.375 [INFO ] [ui.habmin.internal.servlet.HABminApp] - Started HABmin servlet at /habmin
2017-04-30 14:40:31.648 [INFO ] [ing.zwave.handler.ZWaveSerialHandler] - Connecting to serial port '/dev/ttyACM0'
2017-04-30 14:40:31.796 [INFO ] [ing.zwave.handler.ZWaveSerialHandler] - Serial port is initialized
2017-04-30 14:40:31.910 [INFO ] [ve.internal.protocol.ZWaveController] - Starting ZWave controller
2017-04-30 14:40:31.914 [INFO ] [ve.internal.protocol.ZWaveController] - ZWave timeout is set to 5000ms. Soft reset is false.
2017-04-30 14:40:35.483 [INFO ] [age.SerialApiGetInitDataMessageClass] - NODE 1: Node found
2017-04-30 14:40:35.486 [INFO ] [age.SerialApiGetInitDataMessageClass] - NODE 5: Node found
2017-04-30 14:40:35.489 [INFO ] [age.SerialApiGetInitDataMessageClass] - ZWave Controller using Controller API
2017-04-30 14:40:35.491 [INFO ] [age.SerialApiGetInitDataMessageClass] - ZWave Controller is Primary Controller
2017-04-30 14:40:35.492 [INFO ] [age.SerialApiGetInitDataMessageClass] - ------------Number of Nodes Found Registered to ZWave Controller------------
2017-04-30 14:40:35.495 [INFO ] [age.SerialApiGetInitDataMessageClass] - # Nodes = 2
2017-04-30 14:40:35.497 [INFO ] [age.SerialApiGetInitDataMessageClass] - ----------------------------------------------------------------------------
2017-04-30 14:40:54.547 [ERROR] [alization.ZWaveNodeInitStageAdvancer] - NODE 5: SECURITY_INC State=FAILED
2017-04-30 14:40:57.992 [INFO ] [g.discovery.internal.PersistentInbox] - Added new thing 'zwave:device:15bbf4f4afb:node5' to inbox.
A couple of weeks ago when I was trying to add this device, I saw only one channel but now I am seeing 17, so not sure if I am doing something wrong. Here are the channels that I am seeing:
Barrier State
System Alarm (7 channels)
Access Control Alarm (5 channels)
Low battery alarm
Tamper Alarm
General Alarm (2 channels)