Hello community, I’m happy to announce the first version of the new BTicino (Legrand) / OpenWebNet binding for openHAB 2. This is the first known openHAB 2 binding for BTicino/Legrand gateways and devices to support both BUS/SCS and BTicino ZigBee (using USB dongle). Supported so far: WHO=1 Lig…

[image] feodor: My roller shutters are working correctly. firmwareVersion 1.4.5 yes, the USB stick bug affects only fw <= 1.2.0 [image] feodor: I have one problem. After rebooting the raspberry 3b+, the stick does not always start working. Yes send me the logs in a private msg when …

I do not know much because I do not have myhomeserver1 From your browser (chrome or other) from the ip address (I think 192.168.1.35) and enter the configuration

Hello, the problem comes from MyHomeServer1 On my test setup, I have an F454 (2.0.51) and a MyHomeServer1 (2.3.8) I did a test of * # 2 * 0 ## on the 2 webserver Here is the result on the photo. The problem is on MyHomeServer1. It is therefore necessary to contact Bticino to make a correction o…

ok tx Arnaud. I still don’t know how to get my firmware version. I’ll try tomorrow to remove the physical config on all 4 actuators for the shutters and try to access via home_up on mobile, maybe there i could get the version.

Fede, To obtain the firmware number. Open MyHome_Up You add a user, after the search you click on your gateway then you click on “I do not have identifiers” and you connect with the “pin code” installer. Once connected you will know “other” lower right then “system” on the 5th line. You will ha…

[image] tagada: For mine it is: Firmware: 2.2.14 Application: 2.3.8 Do not you offer a firmware update?

[image] tagada: “pin code” installer. If I’m not mistaken, it’s on the webserver’s label [image] https://catalogue.bticino.com/app/webroot/low_res/481351_481434_RA00149AB_U_EN.pdf

Hi all and thanks Massimo for the great job done! I’m an OH2 newbie but, testing with success the 9.2 binding. Using an MH200N as server. Got following stuff working: light switch, dimmer and light general (where 0) thermostat energy management (current energy consumption) Not essential but, wh…

[image] MoriFede: Unfortunately I don’t succeed with shutters as well. There’s no way to make them viewed from openhab. My configuration is as follow: MyHomeServer1 I suggest we close this discussion as this is an already known issue: some updated versions of the BTicino MyHomeServer1 gat…

Hi @marchino , happy to see that a lot of stuff in your system is supported correctly by the binding! [image] marchino: Not essential but, what is the best way to configure central heating thing (99 zones)? The central unit itself is not supported yet, sorry. massi