Enocean Actuators?

Setup, Configuration and Use Beginners
1

Hey everyone,

So I managed to get Fhem up and running, and I can control an EnOcean RCM 250 actuator via web UI. Good stuff. My hardware is working it seems.

I am struggling to understand how to set this up in openHab. Is there a binding procedure? Can I send out telegrams to bind the actuator? Are EnOcean actuators supported at all?

Thanks for your help.
Christian

2

Hi everyone,

Is this just a bad question or just a difficult question? :smile:

Thanks again
Christian

3

So in OpenHAB you need to install the enocean binding by moving the appropriate .jar in the addons folder and configuring the config.

Reading the documentation for this binding ( https://github.com/openhab/openhab/wiki/EnOcean-Binding ) it seems that actuators are not supported, although that might have changed by now and merely the documentation not updated.

As noted in this post: EnOcean: what binding to use? there is another binding. I read a little about this a while ago, and if I remember correctly, this binding also supports actors. I haven’t tried that other binding out myself.
Good luck!