I have a Linear GD00Z Garage Door controller. It shows up in habmin as a NGD00Z-4. When I use the Paper UI or Habmin to link to the various channels, nothing seems to work. I have had no problem adding it to my network, but I cannot control it, nor will it update with the proper open close status. Here is what it shows up as in Habmin. I have also included the xml file. I have tried everything I can think of, granted I am still relatively new to openhab, and have been unsuccessful in making this item work. Any help would be greatly appreciated.
Ok. Just to check if the binding is loaded correctly (I don’t have other ideas of what can be wrong here):
What is the output of the following command in openHAB2 console:
openhab> list -s |grep Z
201 | Active | 80 | 2.1.0.201705311713 | ZWave Binding | org.openhab.binding.zwave
openhab>
(example shown above is for the non-secure Z-Wave)
-bash: Active: command not found
-bash: 80: command not found
-bash: 2.1.0.201705311713: command not found
-bash: 201: command not found
-bash: ZWave: command not found
-bash: org.openhab.binding.zwave: command not found
I cannot get any of those commands to work. I am using a raspberry pi running openhabian. Sorry, I am really new to this. I am logged into the openhabian console, but cannot get the commands to show me any data?
You need to copy the network key (use HABmin), delete your Z-Wave things (PaperUI), uninstall the Z-Wave binding (PaperUI) and then install the new *.jar file manually.
Let me know if you need help with any of the above
Yup… I was right…
The latest Z-Wave Binding with Security has the following version:
2.1.0.201705281057
After you install it manually (download: The jar and place it in /var/share/openhab2/addons/), execute the following in openHAB2 console: feature:install openhab-transport-serial
You will see the following with the list -s |grep Z command in the OH2 console:
Ok that makes sense. This is the first entry style device that I have installed. My next question is: how to do I manually install the correct zwave binding? I have never done this, and up until now, I have been using paper UI to install any bindings etc… I also should add, I am new to linux as well. I have learned a lot, but as you can probably tell, I’m still pretty green. Thanks for your help.
First of all (since you have already included secure devices): keep a copy of your network key
You can find the Network Security Key in PaperUI -> Configuration -> Things -> Controller -> Edit -> Show More
or HABmin -> Configuration -> Things -> Controller -> Z-Wave Network Settings
Then, go to PaperUI and remove all Z-Wave things (including the controller at the end). No need to exclude devices from the Z-Wave network… just delete the things from PaperUI.
Then, uninstall the “standard” Z-Wave binding from PaperUI (do not re-install it from PaperUI !)
Back to the openHABian console (Linux bash shell) now for the manual installation of the binding:
cd /usr/share/openhab2/addons/
wget "http://www.cd-jackson.com/downloads/openhab2/org.openhab.binding.zwave-2.1.0-SNAPSHOT.jar"
Login to the OH2 console and:
feature:install openhab-transport-serial
Hop onto PaperUI, re-introduce your controller (put back the Network Security Key), scan for things and configure them as usual.