Platform information: Hardware: Raspi 3+ with KNX and 1-W hardware board - all working fine OS: Raspbian - latest Java Runtime Environment: Docker image and container openHAB version: 2.5.0: latest Issue of the topic: onewire binding and all 6 sensors (DS18b20) are configured via discovery in…

I do not use this binding, my disclaimer, but have you tried restarting OH since making changes to your configuration? Not sure if this is needed or not but some binding, at least in the past, required a restart after making a change.

After a restart, all things are back online again but no more update at all for any sensor! Config per sensor is still 120s.

Are you running OH in a Docker container and how did you restart OH?

yes I’m running OH in a container; restart via “docker restart container_name”

I do not use docker, will need to search for the correct way to start/stop OH running in docker. Also does docker have enough ram on a Pi3 to work well? Could that be the cause for lag?

@mobil750 not sure if this topic will help or not but it did mention docker running on Pi3. [image] Problems with docker-compose Installation I am trying to move my openHAB installation from Openhabian to a docker based solution on RPI3B. I have created all th…

Docker and OH are working very well on P3+; there is no issue; it’s the Onewire Binding which is not relyable regarding refresh times. I use a docker-compose file; here my file openhab2_5.yml.txt (491 Bytes) you have to remove the “.txt” extension because it is a YAML file; further you have to cr…

[image] mobil750: sometimes the sensors change but the refresh is not as expected on the configured refresh time per sensor Item updates to the same value are not normally shown in events.log, only changes. What makes you think updates are not happening? If in doubt, you could “listen” with…

I use such rules per sensor to forward it to KNX bus. The logs are at same low rate as the OW Events. This causes that my heating controler changes to emergency operation (missing input values over time).

This is a long thread, but gives you insight on using TRACE and what you might expect to see [image] Additional sensors for ESH/OH2 OneWire binding Bindings In the light of #6177 I have started to add additional sensors from Embedded Data Systems. Please try th…

Onewire Binding is not working as expected

Add-ons Bindings

H102 (CM6.5 H102) December 25, 2019, 6:35pm 7

@mobil750 not sure if this topic will help or not but it did mention docker running on Pi3.