Hi, i have some strange problems since i upgraded to OH 4.2. First - Automation for some specific addresses stopped working. I have one rollershutter with adress 80 - this does not work anymore - see log below - 80 is an invalid address? Second - seems like all on/off switches (lights) with addre…

Yes @noxe : starting with 4.2 the binding has a stronger check for configured addresses and as you and @bastler have pointed out the one in your current configuration are not compliant with the Specs. The only accepted formats are those in the image you published What is really strange is that the…

thx Massimo - indeed strange, its working nearly since 10 yers now! :slight_smile:

Hi @noxe , I have the same problem and lost a week trying to reconfigure the whole system (it would have been nice to be informed about this new check in the address…) [image] [OpenWebNet/BTicino] BTicino MyHOME binding for openHAB Bindings Hi all, I have bee…

[image] oppo1967p: Anyway, how did you manage to change the addresses? normally changing the address with myhome_suite should work without problems if the message at the end of the process does not tell you any error. i suppose your switches could be configured physically with jumpers. perhap…

with myhome_suite - after saving your changes - you need to right click → send configuration to device. anyway - what is strange is that you change configure the address to for example - A 8 - PL 0 - even if it should not be allowed based on the docs

Hi, I didn’t set initially those invalid addresses. They have been set by MHS. If I change the wrong addresses manually in MyHome Suite, and send the changes, they appear to be changed, but when I then assign a LIGHT in H+P, then they return to the original value. I use “Advance configuration” n…

Hi I have same problem with this binfing after updating openhab if in the openwebnet.things file I have simiral WHERE like: [ where=“80” ] [ where=“80#4#08” ] [ where=“80#4#09” ] for all this 3 devices openhab give ERROR CONFIG and in details it say: ‘where’ parameter is not configured or is i…

@geoborders : According to the official BTicino documents these are invalid WHERE addresses. Can you change these addresses in your system?

Hi @massi despite several tries, I haven’t been able to change the addresses. They apparently change, but then they return to the previous address. I had to move the lights to another physical plug, and now I cannot use some of the plugs. Considering that also the “invalid” addresses work, PLEAS…

[image] oppo1967p: but then they return to the previous address. does this happen after you cut power on your bticino bus? i suppose the reason for this could be that your switches are configured physically (with jumpers in the switches). if you have jumpers set then always after power loss t…

[OpenWebNet/BTicino] Problems sind OH 4.2

Add-ons Bindings

espresso (Ziad) August 27, 2025, 7:44am 23

Hi Oppo,

I was in the same situation was able to overcome (was a bit painful)

steps are here

Hope this help you out