Pearl irrigation system

[yustbeyourself (Heiko Pfisterer)]

Hello, everyone,
Has anyone of you ever built a Pearl irrigation system into OpenHab?
Like the BWC-510? Royal Gardineer Dual-Bewässerung-Ventile: WLAN-Bewässerungscomputer, 4 Ventile, 2-fach-Wasserverteiler, Sensor (Bewässerungscomputer WLAN App)
How and with which hardware as a gateway?

[Wolfgang_S]

Tuya/SmartLife/Elesion is mentioned on the products page.
According to these buzz words I would assume that this

Tuya devices to Openhab via MQTT - a working solution (without flashing)!

Dear OH-community, I found several postings about adding tuya devices to OH. Thanks to @tsightler finally there is a working solution now. Tom rewrote his whole code with some modifications on the underlaying TuyAPI. One of the highlights here is the easy naming (device names instead id’s) and the OH-friendly path (for example: if you have a power strip with multiple outlets, you can access the mqtt-topic easily by tuya/powerstrip/dps/2/state). Please note that the underlaying TuyAPI doesn’t …

should work

[Flip]

I completely switched over to LinkTap https://www.link-tap.com - the devices are even compatible with Gardena. And the best thing: If you contact their support, they will update your gateway and you will have full MQTT-compatibility out of the box!

Before I used a Tuya Zigbee watering device. But it will be recognized as a light from Deconz. So basically you are only able to switch the valve on and off (no flow values, water usage etc).

[smitopher (Christopher Smith)]

Is the link-tab gateway required? can the link-tap valve controller be directly controlled with the OH zigbee binding?

[Flip]

Unfortunately you will need the Linktap Gateway. But as I mentioned before, you can contact their support and ask for the firmware with mqtt - this firmware gives you also the option to control the devices via http calls