Hi I’m hoping someone can help me with a few issues that I’m having with the particular zwave device configurations. But I am a Zwave newbie, so I’m most likely missing something basic… First things first. I’m running openHABian on a RPi4 with OH 3.1 - its a fresh install, and I have Zwave bindin…

No, have not tried to include securely.

I did the entry in the zwave-db for the zdb5100. I have several of these devices installed, and can confirm that it works from the openhab 3.1 gui. I know that this info does not help you, but I will try to include a new device to see what happens as soon as possible (most likely in the weekend). M…

I managed to do at inclusion(not secure) of a brand new device in openhab 3.1. I did this: Started the scan for new zwave devices Pushed the include button on the device ONCE After a while (20 sec) the device appeared in the inbox Added the device as a new thing Change parameter 10 to 1 Change pa…

Hi. Thanks for taking an interest, and making the entry to the DB - and actually trying this out in 3.1 for me! I’ve included the device in secure mode, other than that my steps were exactly the same, but without your result - when I change the parameter 14 in OH, and physically press the device b…

[image] Zylle: I’ve come across these association groups - I’ve still not gotten my head around those, but could that be needed for the buttons to work properly, For most devices, just the lifeline is required for the device to send status reports. However, as a general statement, association…

[image] chris: you should avoid adding associations ..and I haven’t. It was merely IF associations were needed for these things to work, but clearly not. [image] chris: your issue My issue is that the device does not seem to recieve the commands being sent from at least 1 particular c…

So I think the solution was to include it insecurely, which I marked as the solution. After researching a bit more as to why this was the case, I was hoping perhaps one of you could confirm my theory, since I’m just starting to learn the technicalities. The table shows the supported command classe…

openHAB Community

Problem with configuration and control of Logic Group ZDB 5100 Matrix Zwave device

Add-ons Bindings

Zylle (Mark C) August 2, 2021, 5:33pm 2

Can somebody help with this??

Z-wave device Logic group ZDB5100 not all configuration parameters is visible in habmin