bastler
December 22, 2019, 6:08pm
20
hi thomas,
long time ago i tried to install this binding and had big problems because it always stopped to work after a short time.
perhaps have a look at this new binding for bticino here:
Hello community,
I’m happy to announce the first version of the new BTicino (Legrand) / OpenWebNet binding for openHAB 2.
This is the first known openHAB 2 binding for BTicino/Legrand gateways and devices to support both BUS/SCS and BTicino ZigBee (using USB dongle).
Supported so far:
WHO=1 Lighting (switches/dimmers)
WHO=2 Automation (shutters)
WHO=4 Thermoregulation (thermostats and sensors)
WHO=15/25 CEN/CEN+ (scenario buttons and dry contact / IR sensors)
WHO=18 Energy Management (…
and here:
# OpenWebNet (BTicino/Legrand) Binding - Installation instructions (TESTING version)
//////////////////
This documentation is for the **TESTING version** of the openHAB OpenWebNet binding, which is not part of the openHAB official distribution.
Since the testing phase is now finished, the TESTING version of the binding is not maintained anymore and no support will be provided.
For the documentation of the OpenWebNet binding - official distribution, see here:
[https://www.openhab.org/addons/bindings/openwebnet/](https://www.openhab.org/addons/bindings/openwebnet/)
//////////////////
## Installation
The binding is a TESTING version and not part of the official openHAB distribution.
You must **follow carefully the following instruction steps 1. and 2.** in order to have the binding properly installed and working.
### 1. Bundle Installation
show original
sad to say this binding started very well but now is hardly going on. heating has a bug, and cen only works very basic. because of that i had to code a (very dirty) small python programm that monitors the bus and let me be able to listen and send every command direct to the f454.
best stefan
1 Like
