Z-wave: new device devolo MT:2656

[5iver (Scott Rushworth)]

@Tuny

Also there are some more ‘dead nodes’ discovered. So there still might be a issue with the controller?

This is normal if you have reset the device and then included it again. You can remove them, and this way is built right into Habmin…

Remove a ghost Z-Wave Node from HABmin

Did you already try the “usual” way? Go to HABmin, select your node, Tools … Show advanced settings. Then click “Set device as failed”, wait a minute, then “Remove device from controller”. After that it may still be there but after an openHAB restart it should be gone.