I have now merged the development version of the ZWave binding into master, so it will be available in the 2.4 snapshot version. If you are using the ZWave binding, please read this post as the binding contains some breaking changes so you will need to manually update your configuration. Firstly t…

[image] xsnrg: Multi-sensor 6 on line power, or is it on battery? Battery for all them . . . are you saying try power to it and it will update more often? How often? 15 mins or so? Best, Jay

[image] jwiseman: How often? If USB Powered: with parameter 111 you can set it as low as 30 seconds (I think that minimum is 5 seconds) If it was included using Battery: you may have to exclude it because it keeps the Battery “profile” (default 3600 seconds = 1 hour) [image] Troubl…

[image] dominicdesu: central scene Hello Dominic! I’ve got the same problem like you with the WallC-S Switch. Can you tell me how you’d solved it? How did you change the configuration to “central scene”? Thank you in advance for your help! Best regards, Nico

I manager to get it to work by setting parameter 11 and 12 to 8, Central scene to gateway. Bare in mind that you have to wake up the device and send NIFs several times in general to get the settings into the WallC-S. (Done by holding all 4 buttons for 5 seconds and then pressing button 2) After th…

I updated OH from 2.3 to 2.4 M6. Now I’m experiencing a strange issue with my rollershutters (Fibaro FGR222). Rollershutter rol_WoZi_RolladenWest "Rolladen Wohnzimmer West %" <rollershutter> (gWohnzimmer,gRolladen,gLog) { channel="zwave:device:gehirn:node4:blinds_control", config_inv…

Thanks, that was it… I could delete the parameters from the the item definition it still works well. In my previous stable version 2.3.0 it was working without any problem.

I don’t get it… you had the config_invert_percent in the Item config while on OH2.3.0 and it was working? Are you sure? because from what I understand, this parameter was always supposed to be defined on the Channel settings of your Things file. You didn’t have any warnings in your openhab.log abo…

[image] Dim: because from what I understand, this parameter was always supposed to be defined on the Channel settings of your Things file. Correct. In snapshot #1433, which should be identical to M6, it is still working that way.

I used that binding version: 2018-10-07 19:30:31.565 [INFO ] [internal.service.FeaturesServiceImpl] - mvn:org.openhab.binding/org.openhab.binding.zwave/2.3.0 I had not complains about my items. The controller is defined via file. This is since a long time, I do not remember when I did it. /…

openHAB Community

ZWave binding updates

Setup, Configuration and Use News & Important Changes

Dim (Angelos) November 25, 2018, 10:14am 250

was this config_invert_percent working fine in 2.3.0 Stable?

Check this (note: this is old): Z-Wave Binding invert_state=false and invert_percent=true - #50 by sihui