RasPi not seeing Z-wave Serial port

[rpwong (Russ)]

It’s a known issue between the Raspberry Pi 4 and the Aeotec Z-Stick. Just search for “Aeotec Raspberry Pi 4”.

The solution is to use a USB 2.0 hub.

Raspberry Pi 4 released

Yes, only the aeotec z-stick gen5 has a problem (known) that it is recognized as a USB 3.0 device. However, only USB 2.0 is supported by the stick. By a USB2.0 HUB you can regulate the topic but I use a Geekworm X825 to integrate the SSD, but the micro SD card is still needed for the boot process,

AeoTec Z-Stick Gen5 ZW090 / Raspberry Pi 4 Status offline

I’m a bit intimidated as I’m very new to learning Linux and now trying my first attempt at a DIY home automation project. I’m a installation tech for Network, IP cameras, access control and commercial lighting control systems with Crestron controllers and hardware so I have some basic knowledge to say the least. However I feel almost defeated before I even get a chance to get started as I can not get the Z-wave stick to work. I have installed the Z-wave Bindings, Added Z-wave controller in “t…